SYNTHESIS: To a solution of 43.2 g flaked KOH in 250 mL hot EtOH there was added 96 g 4-methoxyphenol followed by 90 g 2-methylallyl chloride over the course of 2 h. The mixture was held at reflux for 24 h, then added to 1.6 L H2O. There was sufficient 25% NaOH added to make the phase strongly basic, and this was then extracted with 3×200 mL CH2Cl2. The pooled extracts were washed with H2O, and the solvent removed under vacuum. The residue, 125 g of a pale amber oil, was crude 4-(2-methylallyloxy)anisole and was used without further purification in the following reaction.
In a round-bottomed flask containing an internal thermometer, there was placed 125 g of unpurified 4-(2-methylallyloxy)anisole, and this was heated with an open flame. At an internal temperature of 190 °C an exothermic reaction set in, raising the temperature to 250 °C, where it was held for an additional 2 min. After the reaction mixture had cooled to room temperature, it was poured into 500 mL H2O, made strongly basic with 25% NaOH, and extracted repeatedly with 100 mL portions of CH2Cl2 until the extracts were essentially colorless. These extracts were pooled and the solvent removed to provide 80.0 g of a deeply colored oil that proved to be largely the appropriately substituted dihydrobenzofuran. The aqueous residue from above was acidified with concentrated HCl, and again extracted with CH2Cl2. Removal of the solvent gave 17.7 g of 4-methoxy-2-(2-methylallyl)phenol as an amber oil which eventually set down as white crystals with a mp of 52.5–54 °C.
A solution of 17 g of 4-methoxy-2-(2-methylallyl)phenol in 56 g acetic acid was treated with 8.4 g zinc chloride followed with 28 mL concentrated HCl. This mixture was heated at reflux temperature with a mantle for 1 h. After cooling, this was poured into H2O and extracted with 2×150 mL CH2Cl2. The pooled extracts were washed with several portions of 8% NaOH, until the extracts were colorless. The organic fraction was then washed with H2O, and the solvent removed to yield 5.8 g of 2,2-dimethyl-5-methoxy-2,3-dihydrobenzofuran as a pale amber oil with a pungent smell. This was purified by distillation, giving a fraction of an off-white oil with a bp of 136–138 °C at 33 mm/Hg.
To a mixture of 8.0 g N-methylformanilide and 9.2 g POCl3 which had been allowed to stand for 0.5 h, there was added 4.0 g 2,2-dimethyl-5-methoxy-2,3-dihydrobenzofuran, and the mixture held at the steam bath temperature for 2.5 h. This was then poured into 200 mL H2O which produced a black oily phase that gave no hint of crystallization. This mixture was extracted with 3×150 mL CH2Cl2 and the solvent was removed from the pooled extracts under vacuum. The residual oil (which was shown by GC to contain approximately equal quantities of two isomeric benzaldehydes A and B) was extracted with three 75 mL portions of boiling hexane, each of which on cooling deposited a reddish oil that partially crystallized. A fourth hexane extract gave nothing more. The solvent was decanted from these three extracts, and the semi-solid residues were ground under 3.0 mL MeOH giving 1.4 g of pale yellow crystals of 2,2-dimethyl-6-formyl-5-methoxy-2,3-dihydrobenzofuran, isomer “B”. After recrystallization from MeOH, the color was almost white, and the mp was 79.5–80.5 °C. The combined mother liquors were enriched in isomer “A” which proved, following preparative GC separation and NMR analysis, to be the 7-formyl isomer. The 80 g of impure dihydrobenzofuran isolated from the Claisen rearrangement above was distilled and a fraction (43.8 g) that boiled from 138–153 °C at 30 mm/Hg was processed as described here to the aldehyde mixture. Following similar hexane extractions, a yield of 4.0 g of a 95% pure isomer “B” was finally obtained. The remaining components of this fraction were not determined, but it is possible that there were some that contained the six-membered benzopyran ring system.
To a solution of 5.2 g of 2,2-dimethyl-6-formyl-5-methoxy-2,3-dihydrobenzofuran in 20 mL glacial acetic acid there was added 3 mL nitroethane followed by 1.6 g anhydrous ammonium acetate. This mixture was heated for 4 h on the steam bath, and then a small amount of H2O was added to the hot solution. This instigated the formation of a copious deposition of brick-red crystals which were, after cooling, removed by filtration, and recrystallized from 50 mL boiling MeOH. After air drying there was thus obtained 2.7 g of day-glo yum-yum orange crystals of 2,2-dimethyl-5-methoxy-6-(2-nitro-1-propenyl)-2,3-dihydrobenzofuran. An additional 0.6 g of product was obtained by working the mother liquors.
A suspension of 2.5 g LAH in 300 mL refluxing anhydrous Et2O was treated with a solution of 3.1 g 2,2-dimethyl-5-methoxy-6-(2-nitro-1-propenyl)-2,3-dihydrobenzofuran in Et2O. The mixture was held at reflux temperature for 18 h. After cooling, the excess hydride was destroyed by the cautious addition of 400 mL H2O which contained 15 g H2SO4. The aqueous phase was separated, washed once with Et2O, and then once with CH2Cl2. There was then added 60 g potassium sodium tartrate, and the pH was brought to above 10 by the addition of 25% NaOH. This was extracted with 3×250 mL CH2Cl2, the extracts pooled, and the solvent removed under vacuum. There remained 2.8 g of an amber oil with an ammoniacal smell. This was dissolved in 200 mL anhydrous Et2O, and saturated with anhydrous HCl gas. There was the immediate formation of an oil, from which the supernatent Et2O was decanted. The residual oil was resuspended in a second 200 mL anhydrous Et2O, again decanted, and finally a third 200 mL Et2O effected the dissolving of the remaining oil to give a clear solution. All three solutions became gelatinous over the following few h, and each deposited a crop of white crystals over the following few days. From the first there was obtained 1.4 g of product with a mp of 153–154 °C; from the second, 0.2 g with a mp of 153–154 °C; and from the third, 1.2 g with a mp of 155–156 °C. These crops were combined, and recrystallized from 10 mL of boiling CH3CN to give 1.7 g 6-(2-aminopropyl)-2,2-dimethyl-5-methoxy-2,3-dihydrobenzofuran hydrochloride (F-22) as a white crystalline solid which had a mp of 154–155 °C. This material, even when dry, showed a tendency to discolor with time.
DOSAGE: greater than 15 mg.
EXTENSIONS AND COMMENTARY: And here is yet another dihydrobenzofuran which is not of a very high potency if, indeed, it is active at all. This particular dihydrobenzofuran analogue, F-22, had sort of tickled my fancy as being an especially good candidate for activity. It had a certain swing to it. F-22, like
And, as it turned out, the entire project pretty much ran out of steam. A number of clever analogs had been started, and would have been pursued if there had been any activity promised of any kind with any of these dihydrobenzofurans. The “other” benzaldehyde described above, could have been run in a manner parallel to that proposed for the counterpart with
And a start towards
Time to abandon ship. The fact that I had just synthesized and discovered the strange activity of
13 May 2016 · · Isomer Design
About PiHKAL · info
This version of Book II of PiHKAL is based on the Erowid online version, originally transcribed by Simson Garfinkle and converted into HTML by Lamont Granquist. I drew also on “Tyrone Slothrop’s” (Unfinished) Review of PIHKAL to enumerate the many analogues mentioned in PiHKAL but not described at length. Many, many others have since been added.
I have tried here to expunge any artifacts introduced by the earlier transcriptions and restore the typographic niceties found in the printed edition. I’ve also made minor changes to some chemical names in line with current nomenclature practice. Typically the change is little more than expanding a prefix or setting it in italics. The history page has further details.
“At the present time, restrictive laws are in force in the United States and it is very difficult for researchers to abide by the regulations which govern efforts to obtain legal approval to do work with these compounds in human beings.“No one who is lacking legal authorization should attempt the synthesis of any of the compounds described in these files, with the intent to give them to man. To do so is to risk legal action which might lead to the tragic ruination of a life. It should also be noted that any person anywhere who experiments on himself, or on another human being, with any of the drugs described herein, without being familiar with that drug’s action and aware of the physical and/or mental disturbance or harm it might cause, is acting irresponsibly and immorally, whether or not he is doing so within the bounds of the law.”
The copyright for Book I of PiHKAL has been reserved in all forms and it may not be distributed. Book II of PiHKAL may be distributed for non-commercial reproduction provided that the introductory information, copyright notice, cautionary notice and ordering information remain attached.
PiHKAL is the extraordinary record of the authors’ years exploring the chemistry and transformational power of phenethylamines. This book belongs in the library of anyone seeking a rational, enlightened and candid perspective on psychedelic drugs.
Though Sasha and Ann have put Book II of PiHKAL in the public domain, available to anyone, I strongly encourage you to buy a copy. We owe them — and there’s still nothing quite like holding a real book in your hands.
PiHKAL (ISBN 0-9630096-0-5) is available for US$24.50 (plus $10 domestic first-class shipping) from Transform Press.Transform Press,
Berkeley, CA 94701
510 · 934 · 4930 (voice)
510 · 934 · 5999 (fax)