SYNTHESIS: To a solution of 165 g 1,4-dimethoxybenzene in 1 L of CH2Cl2, in a well ventilated place and well stirred, there was cautiously added 300 mL chlorosulfonic acid. With about half the acid chloride added, there was a vigorous evolution of HCl gas and the generation of a lot of solids. As the addition was continued, these redissolved to form a clear, dark green solution. Towards the end of the addition, some solids were again formed. When everything was stable, there was added 2 L H2O, a few mL at a time, commensurate with the vigor of the reaction. The two phases were separated, and the aqueous phase extracted with 2×75 mL CH2Cl2. The original organic phase and the extracts were combined and the solvent removed under vacuum. The residue weighed 162 g and was quite pure 2,5-dimethoxybenzenesulfonyl chloride, a yellow crystalline solid with a mp of 115–117 °C. It need not be further purified for the next step, and it appears to be stable on storage. The sulfonamide, from this acid chloride and ammonium hydroxide, gave white crystals from EtOH, with a mp of 147.5–148.5 °C.
The following reaction is also a very vigorous one and must be performed in a well ventilated place. To a solution of 400 mL 25% H2SO4 (V/V) in a beaker at least 2 L in size, there was added 54 g of 2,5-dimethoxybenzenesulfonyl chloride, and the mixture was heated on a steam bath. The yellow crystals of the acid chloride floated on the surface of the aqueous layer. There should be 80 g of zinc dust at hand. A small amount of Zn dust was placed at one spot on the surface of this chapeau. With occasional stirring with a glass rod, the temperature was allowed to rise. At about 60 or 70 °C an exothermic reaction took place at the spot where the zinc was placed. Additional dollups of zinc were added, and each small exothermic reaction site was spread about with the glass stirring rod. Finally, the reaction spread to the entire solid surface layer, with a melting of the acid chloride and an apparent boiling at the H2O surface. The remainder of the 80 g of zinc dust was added as fast as the size of the reaction container would allow. After things subsided again, the heating was continued for 1 h on the steam bath. After the reaction mixture had cooled to room temperature, it was filtered through paper in a Buchner funnel, and the residual metal washed with 100 mL CH2Cl2. The two-phase filtrate was separated, and the lower, aqueous phase was extracted with 2×75 mL CH2Cl2. The addition of 2 L H2O to the aqueous phase now made it the upper phase in extraction, and this was again extracted with 2×75 mL CH2Cl2. The organic extracts were pooled (H2O washing is more trouble than it is worth) and the solvent removed under vacuum. The light amber residue (30.0 g) was distilled at 70–80 °C at 0.3 mm/Hg to yield 25.3 g 2,5-dimethoxythiophenol as a white oil. This chemical is certainly not centrally active, but it is a most valuable precursor to all members of the
To a solution of 3.4 g of KOH pellets in 75 mL boiling EtOH, there was added a solution of 10.0 g 2,5-dimethoxythiophenol in 60 mL EtOH followed by 10.9 g ethyl bromide. The reaction was exothermic with the immediate deposition of white solids. This was heated on the steam bath for 1.5 h, added to 1 L H2O, acidified with HCl, and extracted with 3×100 mL CH2Cl2. The pooled extracts were washed with 100 mL of 5% NaOH, and the solvent removed under vacuum. The residue was 2,5-dimethoxyphenyl ethyl sulfide which was a pale amber oil, weighed about 10 g and which was sufficiently pure for use in the next reaction without a distillation step.
A mixture of 19.2 POCl3 and 18.0 g N-methylformanilide was heated briefly on the steam bath. To this claret-colored solution there was added the above 2,5-dimethoxyphenyl ethyl sulfide, and the mixture heated an additional 20 min on the steam bath. This was then added to 500 mL of well-stirred warm H2O (pre-heated to 55 °C) and the stirring continued for 1.5 h by which time the oily phase had completely solidified to a brown sugar-like consistency. The solids were removed by filtration, and washed with additional H2O. After being sucked as dry as possible, these solids were dissolved in 50 mL boiling MeOH which, after cooling in an ice-bath, deposited almost-white crystals of 2,5-dimethoxy-4-(ethylthio)benzaldehyde. After filtration, modest washing with cold MeOH, and air drying to constant weight, there was obtained 11.0 g of product with a mp of 86–88 °C. Recrystallization of a small sample again from MeOH provided an analytical sample with mp 87–88 °C. Anal. (C11H14O3S) C,H.
To a solution of 11.0 g 2,5-dimethoxy-4-(ethylthio)benzaldehyde in 100 g of nitromethane there was added 0.5 g of anhydrous ammonium acetate, and the mixture was heated on the steam bath for 80 min (this reaction progress must be monitored by TLC, to determine the point at which the starting aldehyde has been consumed). The excess nitromethane was removed under vacuum leaving a residue that spontaneously set to orange-red crystals. These were scraped out to provide 12.9 g crude
A suspension of 12.4 g LAH in 500 mL anhydrous THF was stirred under He. To this there was added 12.4 g 2,5-dimethoxy-4-ethylthio-β-nitrostyrene in a little THF, and the mixture was held at reflux for 24 h. After the reaction mixture had returned to room temperature, the excess hydride was destroyed by the cautious addition of 60 mL IPA, followed by 20 mL of 5% NaOH followed, in turn, by sufficient H2O to give a white granular character to the oxides. The reaction mixture was filtered, and the filter cake washed first with THF and then with MeOH. Removing the solvents from the combined filtrate and washings under vacuum provided 9.5 g of a yellow oil. This was added to 1 L dilute HCl and washed with 2×100 mL CH2Cl2 which removed all color. After making the aqueous phase basic with 25% NaOH, it was extracted with 3×100 mL CH2Cl2, the extracts pooled, and the solvent removed under vacuum to provide 7.3 g of a pale amber oil. Distillation at 120–130 °C at 0.3 mm/Hg gave 6.17 g of a clear white oil. This was dissolved in 80 mL IPA and neutralized with concentrated HCl, forming immediate crystals of 2,5-dimethoxy-4-ethylthiophenethylamine hydrochloride (2C-T-2). An equal volume of anhydrous Et2O was added and, after complete grinding and mixing, the salt was removed by filtration, washed with Et2O, and air dried to constant weight. The resulting white crystals weighed 6.2 g.
DOSAGE: 12–25 mg.
DURATION: 6–8 h.
QUALITATIVE COMMENTS: (with 12 mg) “I don’t feel this for fully an hour, but when I do it is quite a weight. It feels good to work it through. It is OK to be with pain. You can’t eliminate it. And it is OK to contact your deep pools of anger. And all of it stems from the lack of acknowledgment. All the macho carrying on, the fights, the wars, are ways of demanding attention, and getting even for not having had it in one’s life. I am experiencing more deeply than ever before the importance of acknowledging and deeply honoring each human being. And I was able to go through and resolve some judgments with particular persons.”
(with 20 mg) “I chose 2C-T-2 at this dose level because the lateness of getting started, and I wanted a shorter experience with my daughter and her family around. I feel, however, that I have somewhat less of a body load with
(with 20 mg) “There is a neutralness to this. I am at the maximum, and I am asking myself, ‘Am I enjoying this?’ And the answer is, ‘No, I am experiencing it.’ Enjoyment seems beside the point. It is a rather intensely matter-of-fact +3. Is it interesting? Yes, but mostly in expectation of further developments. Is it inspiring? No. Is it negative? No. Am I glad I took it? Yes. Not glad. Satisfied and contented. This is a controlled +3. No threat. The body is all right. Not superbly healthy—but OK. Of no interest, either way. If I were to define the body’s state, I would have to define it in image. The image is of a not comfortable state of being clenched. Clenched? Well, carefully bound in control.”
(with 22 mg) “A slow onset. It took an hour for a plus one, and almost another two hours to get to a +++. Very vivid fantasy images, eyes closed, but no blurring of lines between “reality” and fantasy. Some yellow-grey patterns a la
(with 25 mg) “I was at a +++ in an hour! It is most difficult to do even ordinary things. I took notes but now I can’t find them. This is much too high for anything creative, such as looking at pictures or trying to read. Talking is OK. And to my surprise I was able to get to sleep, and a good sleep, at the seven hour point.”
EXTENSIONS AND COMMENTARY: There is a considerable parallel between 2C-T-2 and
A point of potential misidentification should be mentioned here. 2C-T-2 has occasionally been called, simply, T-2. This abbreviated nickname has also been used for T-2 Toxin, a mycotoxin of the Tricothecene group, formed mainly by the Fusarium spp. This is the infamous “warfare agent” in Southeast Asia, which was finally identified as bee feces rather than a Soviet military adventure. T-2 and 2C-T-2 are radically different compounds.
All three Tweetios of 2C-T-2 have been made and looked at through human eyes. The 2-EtO-homologue of 2C-T-2 is 2-ethoxy-4-ethylthio-5-methoxyphenethylamine, or
The 5-EtO-homologue of 2C-T-2 is 5-ethoxy-4-ethylthio-2-methoxyphenethylamine, or
The 2,5-DiEtO-homologue of 2C-T-2 is 2,5-diethoxy-4-ethylthiophenethylamine, or
11 Aug 2018 · · Isomer Design
About PiHKAL · info
This version of Book II of PiHKAL is based on the Erowid online version, originally transcribed by Simson Garfinkle and converted into HTML by Lamont Granquist. I drew also on “Tyrone Slothrop’s” (Unfinished) Review of PIHKAL to enumerate the many analogues mentioned in PiHKAL but not described at length. Many, many others have since been added.
I have tried here to expunge any artifacts introduced by the earlier transcriptions and restore the typographic niceties found in the printed edition. I’ve also made minor changes to some chemical names in line with current nomenclature practice. Typically the change is little more than expanding a prefix or setting it in italics. The history page has further details.
“At the present time, restrictive laws are in force in the United States and it is very difficult for researchers to abide by the regulations which govern efforts to obtain legal approval to do work with these compounds in human beings.“No one who is lacking legal authorization should attempt the synthesis of any of the compounds described in these files, with the intent to give them to man. To do so is to risk legal action which might lead to the tragic ruination of a life. It should also be noted that any person anywhere who experiments on himself, or on another human being, with any of the drugs described herein, without being familiar with that drug’s action and aware of the physical and/or mental disturbance or harm it might cause, is acting irresponsibly and immorally, whether or not he is doing so within the bounds of the law.”
The copyright for Book I of PiHKAL has been reserved in all forms and it may not be distributed. Book II of PiHKAL may be distributed for non-commercial reproduction provided that the introductory information, copyright notice, cautionary notice and ordering information remain attached.
PiHKAL is the extraordinary record of the authors’ years exploring the chemistry and transformational power of phenethylamines. This book belongs in the library of anyone seeking a rational, enlightened and candid perspective on psychedelic drugs.
Though Sasha and Ann have put Book II of PiHKAL in the public domain, available to anyone, I strongly encourage you to buy a copy. We owe them — and there’s still nothing quite like holding a real book in your hands.
PiHKAL (ISBN 0-9630096-0-5) is available for US$24.50 (plus $10 domestic first-class shipping) from Transform Press.Transform Press,
Berkeley, CA 94701
510 · 934 · 4930 (voice)
510 · 934 · 5999 (fax)